Solids

About 42 % by volume

Volatile organic compound (VOC)

EU VOC limit value (kat A/d): 130 g/l. The product's VOC: max. 130 g/l.

Practical spreading rate

6 - 10 m²/l depending on the surface.

Density

abt. 1.3 g/ml

Drying time at +23 °C / 50 % RH

- touch dry

- overcoatable

after 3 h

after 16 h

The drying process will be slower in cold and/or damp.

When surfaces painted with NORDICA PRIMER are being top coated with dispersion paints, the painting is done according to the instructions for the paints in question.

Thinner, clean up

Water

Finish

Full-matt

Colours

White and colourless base paint 3. Can be tinted in the Teknomix tinting system. The colour accuracy is not complete.

Packages (availability varies by country)

0,9 L, 2,7 L, 9 L

SAFETY MARKINGS

See Safety Data Sheet.

NOTE! Because of the danger of self-ignition, any waste from the product, spray mist and soiled rags etc. are to be kept in a fire-proof place in air-tight containers. Immersion in water is also recommended.

Surface preparation

Unpainted surfaces are cleaned from loose wood fibers, dirt and dust. Clean mildewed surfaces with RENSA FACADE facade cleaner. Apply a coat of clear WOODEX AQUA BASE priming oil and allow to dry for one day.

Previously painted wooden surfaces that have been cleaned from poorly adherent paint, loose wood fibers and other impurities are washed, if needed, with RENSA FACADE facade cleaner. Wooden parts that are in poor condition are replaced with new ones. Bare wooden surfaces are primed with clear WOODEX AQUA BASE priming oil and are allowed to dry for one day.

NORDICA PRIMER is to be painted only on bare wood prepared according to the surface preparation instructions above, not on top of old paint.

Clean metal surfaces from loose rust, grease and dirt and wire-brush the surfaces before the bare metal surfaces are painted with FERREX AQUA.

Application

Before use stir the paint thoroughly.

Apply by brush or spray.

For painting wooden surfaces dilute the paint about 5 - 10 % with water. If the paint is applied by spray, the surface is to be finished by a brush to ensure the adhesion.

Application conditions

The surface to be painted must be dry.

The moisture of the wood must be below 20 % of the dry weight of the wood.

During the application and drying period the temperature of the ambient air, the surface and the paint shall be above +5 °C and the relative air humidity below 80 %.

STORAGE

Must not freeze.