TRANEMO SVART Black boiled paint
Traditional boiled paint which protects the wood in a natural way.
TRANEMO SVART lets the walls breathe so that the moisture can evaporate through the walls. Finish: full-matt.
To be used on unpainted sawed plank surfaces, unplaned timber surfaces and also on surfaces previously painted with Swedish red paint, e.g. on granaries, outbuildings etc.
The paint is not suitable on planed surfaces or on surfaces that have been painted with other types of paints.
| Technical Data | |
|---|---|
Solids | About 32 % by weight |
Pigment | Iron oxide pigment |
Binder | Boiled linseed oil and wheat flour |
Volatile organic compound (VOC) | EU VOC limit value (kat A/d): 130 g/l. The product's VOC: max. 130 g/l. |
Practical spreading rate | abt. 3 m²/l |
Density | abt. 1.2 g/ml |
Drying time at +23 °C / 50 % RH | Overcoatable after about 4 h The drying process will be slower in cold and/or damp. |
Clean up | Water |
Finish | Full-matt |
Colours | Black |
Packages (availability varies by country) | 10 L |
SAFETY MARKINGS | See Safety Data Sheet. |
| Direction for Use | |
|---|---|
Surface preparation | Untreated sawed plank and rough log surface: Remove dust and dirt and also all loose wood fibres. Wash mildewed surfaces with RENSA FACADE facade cleaner. Prime metal parts with FERREX AQUA anticorrosive paint. Surfaces previously painted with red ochre paint: Remove with steel brush all loose paint from the surface. Coat rusting metal parts with FERREX AQUA anticorrosive paint. |
Application | Apply by a broad brush. First prime with TRANEMO SVART that has been diluted 10 - 20 % with water. Apply the paint in layers as thin as possible until good coverage has been achieved. New surfaces are to be painted twice, surfaces previously painted with red ochre paint are to be painted once or twice. Do not apply on surface warmed by the sun. If the paint dries too quickly, there is a risk of flaking. If flaking occurs, brush off the flaked paint and repaint with thinned TRANEMO SVART. TRANEMO SVART contains iron oxide pigment that is a natural pigment. Therefore little variations of colour might occur. Combine the different paint batches into a same vessel or use the natural lines e.g. corners. NOTE! TRANEMO SVART contains iron sulphate that might dissolve from the painted surface and cause rust stains into light plastered or concrete socles. It might also yellow light wood surfaces. |
Application conditions | During the application and drying period the temperature of the ambient air, the surface and the paint shall be above +5 °C and the relative air humidity below 80 %. The best weather for application is cloudy but dry. |
Storage | Store in a cool place. Must not freeze. |
Technical Data Sheet
Product Image (Hi-Res)