EKORA 2 Ceiling paint
A water-borne, full-matt, fully solvent-free acrylate dispersion paint for interior use.
The product has been classified to Group M1 in Emission Classification of building materials.
The paint is used as a top coat on surfaces in dry interior premises, e.g. on ceilings in apartments, office rooms, walls and ceilings in storerooms and factories.
EKORA 2 can be applied to concrete, plaster, stopper, brick, wood or various building boards.
| Technical Data | |
|---|---|
Solids | About 39 % by volume |
Volatile organic compound (VOC) | EU VOC limit value (kat A/a): 30 g/l. The product's VOC: max. 30 g/l. |
Practical spreading rate | Applied once onto a smooth surface: 6 - 8 m²/l |
Density | abt. 1.6 g/ml |
Drying time at +23 °C / 50 % RH - dust free - overcoatable | after ½ hour after 1 hour The drying will be slowed down if the air is cool and/or humid. |
Thinner, clean up | Water. Wash the equipment immediately after use with water. |
Finish | Full-matt |
Colours | White. Can be tinted with tinting pastes to light shades according to the Interior Colour Cards. The colour accuracy is not complete. |
Washability and wear resistance | The painted surface resists slight wear. Wet scrub resistance, class 3 according to EN 13300 (ISO 11998). |
Packages (availability varies by country) | 18 L |
SAFETY MARKINGS | See Safety Data Sheet. |
| Direction for Use | |
|---|---|
Surface preparation | Clean new surfaces from dust and dirt. Wash previously painted surfaces with RENSA SUPER paint cleaner. Matt down hard or gloss surfaces by sanding and thereafter remove the dust. Remove all of the old paint from the surfaces which have been painted with glue paint or lime wash. Spray filler ceilings, which are not waterproof, are recommended to be primed with solvent borne primer e.g. FUTURA 3 Adhesion primer. For smoothing of irregularities in the surface choose a suitable filler from the SILORA series. The dried filler is sanded down and the dust removed. |
Priming | To prevent the knots bleeding on wood the surfaces are primed with FUTURA 3 Adhesion primer. Steel surfaces are primed with FERREX AQUA Anticorrosive paint. |
Application | Before use stir the paint thoroughly. The paint is thinned with water when needed. Apply once or twice by brush, roller or spray. |
Application conditions | The surface to be painted has to be dry. During the application and drying period the temperature of the ambient air, the surface and the paint shall be above +5 °C and the relative air humidity below 80 %. Good ventilation during the application and drying period quickens the drying process. |
Maintenance instructions | The final forming of the paint film takes abt. 4 weeks under normal circumstances and after that the ultimate durability and hardness is reached. Before this the painted surface must be treated with care. Cleaning by moist wiping or with detergents damages the painted surface. Dry cleaning methods, such as careful wiping, brushing, vacuum cleaning etc., must be used for dirty surface. |
Storage | Must not freeze. |
Technical Data Sheet
Product Image (Hi-Res)