TIMANTTI STOP Insulation primer
Water-borne alkyd based insulation primer for indoor use.
Finish: full-matt.
The product has been classified to Group M1 in Emission Classification of building materials.
Used for previously painted and unpainted soiled concrete, stopper and building board surfaces which can not be washed or otherwise cleaned before top coating.
For walls and ceilings as well as doors, windows and other fixed furniture indoors in dry and humid spaces and in wet rooms. TIMANTTI STOP efficiently insulates and fixes discolourations caused by soot, nicotine and e.g. water damages.
Surfaces insulation primed with TIMANTTI STOP can be top coated with all Teknos interior paints which otherwise suit the object in question.
TIMANTTI STOP is white and full-matt and hence can be used also as a top coat e.g. on ceilings.
| Technical Data | |
|---|---|
Solids | About 40 % by volume |
Volatile organic compound (VOC) | EU VOC limit value (kat A/i): 140 g/l 2010. The product´s VOC: max. 140 g/l. |
Practical spreading rate | 5 - 8 m²/l |
Density | abt. 1.3 g/ml |
Drying time +23 °C, the relative air humidity 50 % - dust free - overcoatable | after 1 hour after 16 hours The best isolation effect is developed after 48 h. The drying will be slowed down if the air is cool and/or humid. |
Thinner, clean up | Water. Wash the equipment immediately after use with appropriate detergent and warm water. |
Finish | Full-matt |
Colours | White |
SAFETY MARKINGS | NOTE! Because of the danger of self-ignition, any waste from the product, spray mist and soiled rags etc. are to be kept in a fire-proof place in air-tight containers, alternatively the waste is to be burned. Immersion in water is also recommended. (See Material Safety Data Sheet, paragraph 7.1.) |
| Direction for Use | |
|---|---|
Surface preparation | Clean the surface from dirt and dust as well as possible. Wash water-resistant dirty surfaces with RENSA Paint Washing Liquid. Remove loose and poorly adherent coats of old paint. Matt down hard or gloss surfaces by sanding and thereafter remove the dust. For smoothing of irregularities in the surface choose a suitable stopper from the SILORA series. The dried stopper is sanded down and the dust removed. Steel surfaces are primed with FUTURA 3 Adhesion primer. TIMANTTI STOP is a water-borne paint. Coatings, which are not waterproof, such as old unpainted ceiling stopper or glue paint coats, must be removed before applying TIMANTTI STOP. Alternatively FUTURA 3 adhesion primer can be used as an insulation primer. |
Application | Before use stir the paint thoroughly. The paint can be diluted with water, if required, but dilution may impair the insulation capability and the coverage of the paint. Apply once or twice by brush, roller or spray. Recommended nozzle size for airless spray is 0.013 - 0.017". |
Top coating | Surfaces insulation primed with TIMANTTI STOP can be top coated with all Teknos interior paints which otherwise suit the object in question. TIMANTTI STOP is white and full-matt and hence can be used also as a top coat e.g. on ceilings. |
Application conditions | The surface to be painted must be dry. During the application and drying period the temperature of the ambient air, the surface and the paint shall be above +10 °C and the relative air humidity below 80 %. Drying is faster in low air humidity and/or above +21 °C. Application will be easier if air is humidified and/or temperature is lowered in the working space. Ventilation after the painting will quicken the drying. |
Storage | Must not freeze. |
Technical Data Sheet
Product Image (Hi-Res)