SILIKATBINDER Silicate primer
Water-borne, inorganic, one component potassium waterglass-based primer for mineral surfaces.
For pretreatment and priming of mineral surfaces in- and outdoors which will be painted with SILIKATFÄRG silicate paint.
See data sheet 924: SILIKATFÄRG silicate paint.
Binds and reinforces brittle substrates and enhances even absorption of the top coat.
| Technical Data | |
|---|---|
Solids | About 7 % by volume |
Binder | Potassium waterglass |
Volatile organic compound (VOC) | EU VOC limit value (kat A/h): 30 g/l 2010. The product´s VOC: max. 30 g/l. |
Practical spreading rate | 3 - 5 m²/l The values may vary considerably depending on the absorbing properties and construction of the substrate. |
Density | 1.1 g/ml |
Drying time +23 °C, the relative air humidity 50 % Overcoatable | after 12 h The drying process will be slower in cold and/or damp. |
Thinner, clean up | Water |
Finish | Matt |
Colours | Clear |
Packages (availability varies by country) | 10 L |
SAFETY MARKINGS | See Material Safety Data Sheet. |
| Direction for Use | |
|---|---|
Surface preparation | NEW SURFACES: It is recommended that new plaster surfaces are coated only after a hardening time of 6 - 8 weeks. Remove all dirt, dust and other loose impurities from the surfaces by cleaning with high pressure washer, if needed. See data sheet 924: SILIKATFÄRG silicate paint. PREVIOUSLY PAINTED SURFACES: Remove flaking and poorly adherent or chalking, pulverized (e.g. lime wash) old paint coats. The method to be used is chosen depending on the strength of the substrate and the type of the paint to be removed (e.g. wire-brushing, hot pressurized-water cleaning or water-sand cleaning). |
Priming | Before use stir the product thoroughly. Priming is not needed on solid cement plaster, concrete or painted surfaces. Strongly absorbent porous substrates, such as plaster and surfaces painted with lime paint, are pretreated with SILIKATBINDER Silicate Primer diluted with water in the ratio of 1:1. NB! Silicate primer and paint are corrosive. Protect glass, glazed, natural stone and metal surfaces. |
Priming | PRIMING is done with a mixture of SILIKATFÄRG Silicate Paint and SILIKATBINDER Silicate Primer. Mixing ratio 2:1. |
Application methods | Apply the primer by brush, roller and/or airless spray. Recommended nozzle size for spray is 0.013 - 0.017". |
Application conditions | During the application and drying period the temperature of the ambient air, the surface and the paint shall be above +10 °C and the relative air humidity below 80 %. Avoid painting in direct sunlight. |
STORAGE | Must not freeze. Storage life: about 12 months. |
Technical Data Sheet
Product Image (Hi-Res)