TEKNOFLOOR Floor paint
Solvent-based urethane alkyd paint for interior and exterior floors. It produces a gloss surface that is easy to keep clean. Finish: gloss.
Suitable for new and previously with alkyd or acrylic paints painted floors of concrete and wood, when the surfaces are affected by normal household strains.
It is recommended that TEKNOFLOOR 2K Concrete Paint is used when painting floors that will be subjected to strong action by water or chemicals, or to heavy abrasion.
The paint has CE approval for protection of concrete structures.
| Technical Data | |
|---|---|
Solids | About 50 % by volume |
Volatile organic compound (VOC) | EU VOC limit value (kat A/i): 500 g/l. The product´s VOC: max. 500 g/l. |
Practical spreading rate | 7 - 9 m²/l depending on the absorbency of the surface |
Density | Abt. 1.2 g/ml |
Drying time, +23 °C - dust free - fit for light traffic - overcoatable | after 1 hour after 10 hours the following day The drying process will be slower in cold and/or damp. |
Thinner, clean up | TEKNOSOLV 1621 (solvent naphtha) |
Finish | Gloss |
Colours | Standard colours according to the TEKNOFLOOR Colour Card. The paint is included in the Teknomix tinting system. |
Packages (availability varies by country) | 0,9 L, 2,7 L, 9 L |
SAFETY MARKINGS | See Material Safety Data Sheet. NOTE! Because of the danger of self-ignition, any waste from the product, spray mist and soiled rags etc. are to be kept in a fire-proof place in air-tight containers. Immersion in water is also recommended. |
| Direction for Use | |
|---|---|
Surface preparation and application | UNCOATED CONCRETE FLOORS are to be at least one month old. Clean the surfaces from dense laitance by etching with BETONI-PEITTAUSLIUOS Etching liquid and allow the surfaces to dry. Brittle and powdery surfaces must always be gleaned by grinding. Remove oil and grease with solvent TEKNOSOLV 1621. Brush the floor or clean with vacuum-cleaner to remove the dust. Prime the surface with paint diluted by 20 % with TEKNOSOLV 1621 and finish with one coat of undiluted paint. UNPAINTED WOODEN FLOORS: Clean the floors from grease, dirt and dust. Fill dents and cracks with SILORA A Carpentry Filler. Prime with paint diluted by 10% with TEKNOSOLV 1621 and finish with one coat of undiluted paint. PREVIOUSLY PAINTED FLOORS: Scrape or sand off all loose paint. Matt down old paint coats by sanding. Clean the surfaces from grease, dirt and dust. Prime bare spots with diluted paint and finish with a full coat of undiluted paint. Before use stir the paint thoroughly. Apply the paint by brush, roller or spray. Use airless spray nozzle 0.013 - 0.017". |
Application conditions | The surface to be painted must be dry. During the application and drying period the temperature of the ambient air, the surface and the paint shall be above +10 °C and the relative air humidity below 80 %. |
Care instructions | The painted surface reaches its final hardness and washability within 3 - 4 weeks. Rough handling and washing is to be avoided during this period. Stained surfaces can be cleaned with a moist cleaning cloth or mop. Use a neutral detergent. Very dirty surfaces can later be cleaned with a slightly alkaline universal washing detergent. |
| CE information | |||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
CE MARKING |
| ||||||||||||||||||
Technical Data Sheet
Product Image (Hi-Res)
Declaration of Performance