TALOMAALI
Water-borne acrylate-based outdoor paint. Finish: semi-matt.
For wooden surfaces that are either new or previously painted with dispersion or oil paint, e.g. facades, facial boards, weather boards and window boards. For log surfaces we recommend WOODEX AQUA CLASSIC wood stain.
NOTE! For surfaces previously painted with red ochre paint we recommend new treatment with red ochre paint.
| Technical Data | |
|---|---|
Solids | About 38 % by volume |
Volatile organic compound (VOC) | EU VOC limit value (kat A/d): 130 g/l. The product's VOC: max. 130 g/l. |
Practical spreading rate | Planed timber Sawn timber 8 m²/l 5 m²/l |
Density | abt. 1.3 g/ml |
Drying time at +23 °C / 50 % RH - touch dry - overcoatable | after 1 hour after 2 - 4 hours The drying process will be slower in cold and/or damp. |
Thinner, clean up | Water. Wash the equipment immediately after use with detergent and warm water. |
Finish | Semi-matt |
Colours | According to the Colour Cards for exterior paints The paint is included in the Teknomix tinting system. |
Weather resistance | Very good. |
Packages (availability varies by country) | 2,7 L, 9 L, 18 L |
SAFETY MARKINGS | See Safety Data Sheet. |
| Direction for Use | |
|---|---|
Surface preparation and priming | NEW WOODEN SURFACE: Treat the surface as soon as possible. At least the impregnation and priming would be best done in the summer of construction. Remove from the surface all loose matter, dirt, dust and mildew. If needed, use RENSA FACADE facade cleaner. Apply a coat of clear WOODEX AQUA BASE priming oil. Allow to dry for one day. Prime wooden surfaces with NORDICA PRIMER and allow the surfaces to dry for 1 - 3 days depending on the weather. Wash the metal parts with TEKNOSOLV 1621 (solvent naphtha) and prime with FERREX AQUA. PREVIOUSLY PAINTED OR OLD WOODEN SURFACE: Change the deteriorated wooden parts to new ones. Remove loose matter, dirt and dust. Remove the deteriorated paint coats entirely. Note, that the adherence of an old thick paint layer to the substrate may have been weakened, therefore the paint should be removed although the paint film looks intact. The old paint layer is removed primarily by scraping or wire brushing and possibly by heating the surface with infra-red heater designed for that purpose. Secondarily paint remover or blasting can be used. Wash surfaces with RENSA FACADE facade cleaner and rinse thoroughly. Old, untreated wooden surfaces can before the priming be treated with clear WOODEX AQUA BASE priming oil, see ´NEW WOODEN SURFACE´. Prime bare wooden surfaces with NORDICA PRIMER. Allow to dry for 1 to 3 days depending on the weather. Wire-brush the rusty metal parts. Wash all metal parts with TEKNOSOLV 1621 (solvent naphtha) and prime with FERREX AQUA. |
Top coating | Reserve a sufficient amount of paint in the same vessel for each uniform surface. Colour differences will thus be avoided. Stir the paint well and apply by paint brush or spray once or twice. If the paint is applied by spray, the surface is to be finished by a brush to ensure the adhesion. |
Application conditions | The surface to be painted must be dry. The moisture of the wood must be below 20 % of the dry weight of the wood. During the application and drying period the temperature of the ambient air, the surface and the paint shall be above +5 °C and the relative air humidity below 80 %. Avoid application in direct sunlight. |
ADDITIONAL INFORMATION | Must be stored tightly closed and kept cool. MUST NOT FREEZE. |
Technical Data Sheet
Product Image (Hi-Res)