Teknos tuotteet

Teknoksen offline-tuotetietokirjasto

  • Jälleenmyyjien käyttöön sävytyskoneille Teknoksen tuotetiedot helppokäyttöisessä muodossa.

PANEELILAKKA Interior varnish

       

PANEELILAKKA Panel Varnish is a water-based nearly odourless dispersion varnish that contains agents that protect against ultraviolet light.

Especially suitable for varnishing panelled walls and ceilings. Is also suitable for use on chipboard walls and ceilings.

The varnish is not recommended for floors, parquets or furniture.

Technical Data

Solids

About 33 % by volume

Volatile organic compound (VOC)

EU VOC limit value (kat A/e): 130 g/l 2010. The product´s VOC: max. 130 g/l.

Practical spreading rate

10 - 14 m²/l

Density

1.0 g/ml

Drying time +23 °C, the relative air humidity 50 %

- dust free

- fit for sanding and overcoating

- fit for service

after ½ hour

after 12 h

the following day

Thinner, clean up

Water. Wash the equipment immediately after use with detergent and warm water.

Finish

Semi-matt

Colours

Clear

The varnish is included in the Teknomix tinting system.
Direction for Use

Surface preparation Application

Remove grease and dirt. Matt down old, intact varnished surface by sanding. If the varnished surface is flaking, remove it by sanding.

Stir the varnish carefully down to the bottom of the can. Apply the varnish twice along the direction of the wood grain. After the first application the surface can be lightly sanded to removeuplifted wood fibers. For the first application the varnish can be diluted with water.

The second application is done with undiluted varnish.

Application conditions

During the varnishing and drying period the temperature of the ambient air, the surface and the varnish shall be above +10 °C and the relative air humidity below 80 %.

Storage

Must not freeze.

The information of this data sheet is based on laboratory tests and practical experience. The figures are for guidance only and depend on, for example, colour and gloss. As we have no control over the use and application conditions, we are only responsible for the quality of the product and guarantee that it conforms to our quality control. We accept no liability for any loss or damage resulting from the application of the product contrary to the directions or the intended use. The latest versions of our data sheets, material safety data sheets and system sheets are on our home pages www.teknos.com.