NATURA 40 Semigloss interior varnish
Water-borne acrylate varnish that contains an effective UV absorber. It gives good flow, dries quickly, is almost odourless and does not yellow. After drying the varnish coat withstands washing and abrasion. Finish: semigloss.
The product has been classified in Emission Classification of building materials to Group M1.
NATURA 40 is suitable for use on internal woodwork, such as walls, ceilings, panelling and indoor log walls. Not suitable for varnishing of furniture or floors.
| Technical Data | |
|---|---|
Solids | About 25 % by volume |
Volatile organic compound (VOC) | EU VOC limit value (kat A/e): 130 g/l. The product's VOC: max. 130 g/l. |
Practical spreading rate | 8 - 14 m²/l |
Density | abt. 1.0 g/ml |
Drying time +23 °C, the relative air humidity 50 % - dust free - overvarnishable - fit for service | after ½ hour after 1 hour after 8 hours The varnish obtains its final hardness after about 2 - 3 weeks. The drying process will be slower in cold and/or damp. |
Thinner | Water |
Clean up | Water and synthetic washing agent |
Finish | Semigloss |
Colours | Clear The varnish is included in the Teknomix tinting system. |
Packages (availability varies by country) | 0,9 L, 2,7 L, 9 L |
SAFETY MARKINGS | See Safety Data Sheet. |
| Direction for Use | |
|---|---|
Surface preparation | Clean the surfaces by washing with RENSA SUPER paint cleaner, sanding or brushing. Clean old, intact varnish coats from grease and dirt and matt them down. If the varnish coat is weathered or flaking, it is removed entirely by sanding. Old varnish coats can also be stripped off with paint remover and scraper. Thereafter the surface is sanded. |
Varnishing | Stir the varnish thoroughly down to the bottom of the can before use. Thin NATURA 40 for priming by adding up to 15% water. Apply by a 3 - 4" varnish brush, conventional or airless spray. The spraying viscosity should be 25 - 40 s, DIN 4. Use airless spray nozzles 0.009 - 0.015". When the first coat has dried it can be sanded lightly to remove protruding wood fibres. Use undiluted varnish for the second coat. If a very fine and durable finish is desired, apply three coats of varnish. Rub down the surface carefully before the finish coat is applied. |
Application conditions | During the varnishing and drying period the temperature of the ambient air, the surface and the varnish shall be above +10 °C and the relative air humidity below 80 %. |
Storage | Must not freeze. |
Technical Data Sheet
Product Image (Hi-Res)