Teknos tuotteet

Teknoksen offline-tuotetietokirjasto

  • Jälleenmyyjien käyttöön sävytyskoneille Teknoksen tuotetiedot helppokäyttöisessä muodossa.

WOODEX WOOD OIL

     

Solvent-borne penetrating and drying oil for outdoor use.

Used for surface treatment of new and press-impregnated wood, wood treated by penetrating wood stains, and also for surface treatment of teak, oak, mahogany and hardwood. Typical objects are garden furniture, jetties, fences, trellises and doors.

Protects the wood from drying, cracking and soiling and when coloured from UV radiation of the sun. Optimum durability is achieved by renewing the WOODEX WOOD OIL treatment yearly.

Not suitable for greenhouses, hotbeds or shelters for livestock.

Technical Data

Solids

About 30 % by volume

Volatile organic compound (VOC)

The product is not included in the EU VOC directive.

Practical spreading rate

Sawn timber

Planed timber

5 - 8 m²/l

8 - 10 m²/l

Density

abt. 0.85 g/ml

Drying time, +23 °C

- touch dry

- dry

after 8 hours

after 16 hours

The drying process will be slower in cold and/or damp.

Thinner, clean up

To be used without thinning. The equipment is washed immediately after use with TEKNOSOLV 1621 (solvent naphtha).

Finish

Is absorbed into the wood and does not usually form any visible film.

Colours

Clear, brown, grey and translucent colours.

Weather resistance

For surfaces that are continuously exposed to weathering a renewed treatment is necessary once a year.

Packages (availability varies by country)

0,9 L, 2,7 L, 9 L

SAFETY MARKINGS

See Safety Data Sheet.

NOTE! Because of the danger of self-ignition, any waste from the product, spray mist and soiled rags etc. are to be kept in a fire-proof place in air-tight containers. Immersion in water is also recommended.
Direction for Use

Surface preparation

Remove from the surface all loose matter, dirt and dust. Use RENSA TERRACE deck cleaner on surfaces to be treated, when needed. Rinse the surfaces thoroughly with water and allow to dry.

Remove old paint or varnish layers before the treatment.

Application

Before use stir the product thoroughly down to the bottom of the can.

The product must also be repeteadly stirred down to the bottom of the can during the application. Apply WOODEX WOOD OIL by brush, sponge or spray. Dipping can also be used.

Renew the treatment according to the quality of wood until the surface doesn't absorb more oil. Wipe off possible excess oil abt. 30 min after the application.

Application conditions

The surface to be treated must be dry. The relative moisture of the wood must be below 20 % of the weight of the wood.

During the application and drying period the temperature of the ambient air, the surface and the product shall be above +5 °C and the relative air humidity below 80 %.

The information of this data sheet is based on laboratory tests and practical experience. The figures are for guidance only and depend on, for example, colour and gloss. As we have no control over the use and application conditions, we are only responsible for the quality of the product and guarantee that it conforms to our quality control. We accept no liability for any loss or damage resulting from the application of the product contrary to the directions or the intended use. The latest versions of our data sheets, material safety data sheets and system sheets are on our home pages www.teknos.com.