Teknos tuotteet

Teknoksen offline-tuotetietokirjasto

  • Jälleenmyyjien käyttöön sävytyskoneille Teknoksen tuotetiedot helppokäyttöisessä muodossa.

WOODEX AQUA BASE Priming oil

     

Water-borne priming oil for treatment of wooden surfaces outdoors before top coating is applied. Containts agents that give the wood effective protection against blue stain fungi, mildew and wood rot.

WOODEX AQUA BASE penetrates deep into the wood without forming any film, and gives the surface a long-lasting protection under the top coating.

Priming on planked and log surfaces, porches, jetties, garden furniture and similar untreated wooden surfaces.

Surfaces primed with WOODEX AQUA BASE should be top coated as soon as possible. Suitable top coatings are Teknos´ water- and solvent-borne wood stains, primers, facade paints and furniture paints for wooden surfaces outdoors.

Technical Data

Solids

About 5 % by volume

Volatile organic compound (VOC)

The product is not included in the EU VOC directive.

Practical spreading rate

Planed timber

Sawn timber

8-10 m²/l

4-8 m²/l

Density

1.0 g/ml

Drying time at +23 °C / 50 % RH

Does not form any film and thus the surface feels dry as soon as the substance has been absorbed.

Overcoatable the following day.

Clean up

Clean the equipment immediately after use with warm water and detergent.

Colours

Clear

SAFETY MARKINGS

See Material Safety Data Sheet.
Direction for Use

Application

Apply WOODEX AQUA BASE to a clean and dry surface with a soft brush, by spraying or by dipping for 15 min - 12 h. The best anti-rot effect is achieved by immersing for several hours.

Treat end grain and other porous areas several times.

Application conditions

The surface to be treated must be dry.

The moisture of the wood must be below 20 % of the dry weight of the wood.

During the application and drying period the temperature of the ambient air, the surface and the priming oil shall be above +5 °C and the relative air humidity below 80 %.

STORAGE

Must not freeze. The best storage temperature is between +10 - +25°C.

The information of this data sheet is based on laboratory tests and practical experience. The figures are for guidance only and depend on, for example, colour and gloss. As we have no control over the use and application conditions, we are only responsible for the quality of the product and guarantee that it conforms to our quality control. We accept no liability for any loss or damage resulting from the application of the product contrary to the directions or the intended use. The latest versions of our data sheets, material safety data sheets and system sheets are on our home pages www.teknos.com.