Teknos tuotteet

Teknoksen offline-tuotetietokirjasto

  • Jälleenmyyjien käyttöön sävytyskoneille Teknoksen tuotetiedot helppokäyttöisessä muodossa.

WOODEX BASE Priming oil

    

Solvent-borne priming oil for treatment of wooden surfaces outdoors before top coating is applied. Containts agents that give the wood effective protection against blue stain fungi, mildew and wood rot.

WOODEX BASE is absorbed well into all kinds of wooden surfaces and it is also suitable for oily wood sorts such as oak, teak, mahogany, so-called hardwood etc.

Priming on planked and log surfaces, porches, jetties, garden furniture and similar untreated wooden surfaces.

Surfaces primed with WOODEX BASE should be top coated as soon as possible.

Suitable top coatings are Teknos´ water- and solvent-borne wood stains, primers, facade paints and furniture paints for wooden surfaces outdoors.

Technical Data

Solids

About 5 % by volume

Volatile organic compound (VOC)

The product is not included in the EU VOC directive.

Practical spreading rate

Sawn timber

Planed timber

4 - 8 m²/l

8 - 10 m²/l

Practical spreading rate

The quality and moisture of the wood affect the spreading rate.

Density

abt. 0.8 g/ml

Drying time at +23 °C / 50 % RH

The priming oil does not form any film and thus the surface feels dry as soon as the oil has been absorbed.

WOODEX BASE is overcoatable and -varnishable after 1 h by solvent-borne paints and after 16 h by water-borne paints.

Washing the equipment

TEKNOSOLV 1621 (solvent naphtha)

Colours

Clear

SAFETY MARKINGS

See Material Safety Data Sheet.
Direction for Use

Application

Apply WOODEX BASE to a clean and dry surface with a soft brush, by spraying or by dipping.

Treat end grain and other porous areas several times.

Application conditions

The surface to be treated must be dry.

The moisture of the wood must be below 20 % of the dry weight of the wood.

During the application and drying period the temperature of the ambient air, the surface and the priming oil shall be above +5 °C and the relative air humidity below 80 %.

The information of this data sheet is based on laboratory tests and practical experience. The figures are for guidance only and depend on, for example, colour and gloss. As we have no control over the use and application conditions, we are only responsible for the quality of the product and guarantee that it conforms to our quality control. We accept no liability for any loss or damage resulting from the application of the product contrary to the directions or the intended use. The latest versions of our data sheets, material safety data sheets and system sheets are on our home pages www.teknos.com.