Teknos tuotteet

Teknoksen offline-tuotetietokirjasto

  • Jälleenmyyjien käyttöön sävytyskoneille Teknoksen tuotetiedot helppokäyttöisessä muodossa.

RENSA Mildew Remover

    

RENSA Mildew Remover is a cleaning agent based on hypochlorite. It is intended for cleaning wooden and painted surfaces from mildew.

Technical Data

TECHNICAL DATA

Use RENSA Mildew Remover either undiluted or diluted 20 % with water.

Apply by brush or spray. Moisten the mildewed surface 1 - 2 times with the Mildew

Remover. Wash from below and proceeding upwards. For better cleaning effect, brush the surface with a smooth brush.

Rinse the surface thoroughly after about 15 minutes with fresh water.

Allow the surfaces to dry before they are painted.

Protect metal parts during the cleaning, as RENSA Mildew Remover may cause oxidation of metal.

Protect also garden plants from splashes.

STORAGE

Must not freeze.

WORK SAFETY

Wear protective gloves and eye protection. Rinse off splashes from the skin with water. Warning! Do not use together with other products. May release dangerous gases (chlorine).

The information of this data sheet is based on laboratory tests and practical experience. The figures are for guidance only and depend on, for example, colour and gloss. As we have no control over the use and application conditions, we are only responsible for the quality of the product and guarantee that it conforms to our quality control. We accept no liability for any loss or damage resulting from the application of the product contrary to the directions or the intended use. The latest versions of our data sheets, material safety data sheets and system sheets are on our home pages www.teknos.com.