Solids

About 63 % by volume

Layer thickness

0 - 30 mm

Volatile organic compound (VOC)

The product is not included in the EU VOC directive.

Practical spreading rate

For skimming the entire surface, 1 l/m² with 1 mm layer thickness. For partial filling of surfaces and filling of joints, two layers on gypsum board, abt. 0.3 l/m².

Particle size

Max. 0.3 mm

Density

0.8 g/ml

Drying time +23 °C, the relative air humidity 50 %

2 - 3 hours/mm up to a layer thickness of 10 - 15 mm. Layers thicker than this dry considerably slower.

The drying process will be slower in cold and/or damp.

Clean up

Water

Colours

Grey

Packages (availability varies by country)

10 L

SAFETY MARKINGS

See Safety Data Sheet.

Surface preparation

Clean new surfaces from dust and dirt.

Wash previously painted surfaces with RENSA SUPER paint cleaner.

Matt down hard or gloss surfaces by sanding and thereafter remove the dust.

Brittle surfaces and untreated wooden surfaces must be primed before the filler is applied.

Application method

Apply the filler by trowel. The number of layers is dependent on the surface roughness.

The use of protective mask for eyes and face is recommended when grinding the filler.

Surfaces filled with TEKNOSPRO BREPLASTA LG must before further treatment be entirely skimmed over with a finer-graded filler to ensure better adhesion and a smoother surface.

Application conditions

The surface to be treated must be dry.

The temperature of the air, the surface and the filler shall be above +5 °C and the relative humidity of the air below 80 % during the time of application and drying.

Storage

To be stored in a cool place. Must not freeze. Storage stability is 1 year in unopened package.

CE MARKING