TeknosPro W Wet-room filler
Ready-to-use, light, water-borne wet-room filler for spray application.
Used for filling joints and overall skimming of walls and ceilings in wet interior areas when a filler harder than usual is needed. The substrate can be gypsum, fibre board, concrete, lightweight concrete, plaster etc. Also suitable for smoothing out of board joints and for attaching jointing tape.
TEKNOSPRO W has good moisture resistance and adhesion. It also gives a harder surface than other fillers.
The product has CE approval.
| Technical Data | |
|---|---|
Solids | About 59 % by volume |
Layer thickness | 0 - 4 mm |
Volatile organic compound (VOC) | The product is not included in the EU VOC directive. |
Practical spreading rate | For skimming the entire surface, 1 l/m² with 1 mm layer thickness. For of joints abt. 0,2 l/m². |
Particle size | Max. 0.15 mm |
Density | 1.1 g/ml |
Drying time +23 °C, the relative air humidity 50 % | 2 - 5 hours/mm depending on the layer thickness. The drying process will be slower in cold and/or damp. |
Clean up | Water |
Colours | Light blue |
Packages (availability varies by country) | 15 L |
SAFETY MARKINGS | See Safety Data Sheet. |
| Direction for Use | |
|---|---|
Surface preparation | Clean new surfaces from dust and dirt. Wash previously painted surfaces with RENSA SUPER paint cleaner. Matt down hard or gloss surfaces by sanding and thereafter remove the dust. Brittle surfaces and untreated wooden surfaces must be primed before the filler is applied. |
Application method | Apply the filler with a paste-spraying gun or a trowel. Recommended nozzle size for airless spray is 0.029 - 0.035". The number of layers is dependent on the surface roughness. The dried filler can be painted or wall-papered. Before wall-papering the filler surfaces must be pre-glued. The use of protective mask for eyes and face is recommended when sanding the filler. |
Application conditions | The surface to be treated must be dry. The temperature of the air, the surface and the filler shall be above +5 °C and the relative humidity of the air below 80 % during the time of application and drying. |
Storage | To be stored in a cool place. Must not freeze. Storage stability is 1 year in unopened package. |
| CE information | |||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
CE MARKING |
| ||||||||||
Technical Data Sheet
Product Image (Hi-Res)